Tork Craft | Diamond Core Bit 6mm for Tiles
R104
Available in stock
Description
Diamond Core Bit
Core diameter:
Ø6mm
Main use:
Tiles
The diamond core bit is used to drill holes in:
Ceramic tiles
Marble
Grade 5 porcelain (hardest)
Granite
Glass
Slate
The diamond core cuts faster, smoother and lasts longer than any other core drills.
How to use the diamond core bit
The diamond core drill bit must be used with water at all times when drilling. The water serves as a coolant to prevent the diamonds from overheating. The maximum allowable temperature for a diamond core bit is 500°C.
There is no pilot drill with the diamond core bit. A low rpm rotary drill with a planetary gearbox is required to be used with a diamond core bit. It is possible to use a cordless drill, but in the lowest gear setting. No hammer action is used.
Tightly fasten the diamond core bit in the drill’s chuck
Keep the bit steady at a 45° angle with the starting point on the edge of the assigned area to be drilled whilst the bit is rotating
A notch will be made (this is normal)
Gradually move the drill from 45° to 90° and continue drilling until finished
Allow the diamond core bit to cool down completely before proceeding to drill another hole
Water can be applied by
spraying water on the surface
using a wet sponge
attaching a water feed device (this is necessary when drilling into a wall tile)
An indication of the correct spindle speed
DIAMOND CORE BIT DIAMETER
SPINDLE SPEED
Ø5,0mm
800rpm
Ø6,0mm
600rpm
Ø7,0mm
500rpm
Ø8,0mm
500rpm
Ø10,0mm
400rpm
More than Ø10,0mm (>10,0mm)
less than 400rpm
IMPORTANT:
The tool life will mostly depend on the proper usage and the hardness of the items drilled into. It is normal for a diamond core bit to last up to 10 or more drilled holes in hard tiles. Please remember to
always
use water when drilling with diamond core bits.
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.